Speed Sensor (8 Pulse/Rev)
This is the Speed Sensor used with our Belt Weighing Systems. It is supplied with a “Jockey Wheel Assembly” designed to run on the clean side of the return belt. The heavy duty wheel is 200mm in diameter and the “standard” unit generates 8 pulses per revolution of the wheel. The unit is supplied complete with 7m of high quality, abrasion resistant cable.
Sensor Type: Magnetically Biased Hall Effect Integrated Circuit
Pulses Per Rev: 8
Supply Voltage: 4.5 to 24 VDC
Temp. Range: -40 to +150 deg C
Reverse Polarity Protection (ie. No damage if inadvertently wired in reverse)
Protection against pulsed transients to +60V, to -40V.
Pull Up Resistor Fitted (1K ohm) to provide High standard signal and “Low going” pulse when target passes the sensor.